mitaux8030
Silent Key
I've observed some unusual behaviour with some EDACS SCAT systems here.
One system was programmed as a 3-channel site (as that is what its licenced to use, but the site is actually operating as a SCAT) and when HOLD'ing on the control channel, the EDACS site ID is not shown, until there is a voice transmission.
However, other SCAT sites (and programmed as such in the 396T) don't display the EDACS site ID at all, even after several voice transmissions.
Is this just a quirk of the 396T?
Thanks,
Jason
One system was programmed as a 3-channel site (as that is what its licenced to use, but the site is actually operating as a SCAT) and when HOLD'ing on the control channel, the EDACS site ID is not shown, until there is a voice transmission.
However, other SCAT sites (and programmed as such in the 396T) don't display the EDACS site ID at all, even after several voice transmissions.
Is this just a quirk of the 396T?
Thanks,
Jason