396t

[6520tkp]

Several times her latley on my 396T I hear a beep and a message stating " press E to listen", at the time I was scanning a Motorola 800 trunking and a 700 MHZ digital system.

Any ideas.

Thanks.

 

[mikewazowski]

Sounds like you might have Close Call turned on and it's found a frequency.

 

[W8RMH]

Several times her latley on my 396T I hear a beep and a message stating " press E to listen", at the time I was scanning a Motorola 800 trunking and a 700 MHZ digital system.

Any ideas.

Thanks.

Set Close Call Mode this turns Close Call on when scanning or searching. You can also do this by pressing and holding Func then pressing Hold while scanning or searching.
Scroll to 'Set CC Mode' and press E/yes.
Scroll to 1 of 3 modes and press E/yes to save and exit.
Off- Close Call is turned off.
CC DND- (Requires firmware 3.00 or newer) Close Call checks for frequencies every two seconds between transmissions.
Pri- Close Call checks for frequencies every two seconds.

From: Easier to Read BCD396T/UBCD396T Digital Scanner Manual