BCD436HP/BCD536HP: 436HP with GPS and Tower Coordinate using Sentinel

[morrisr3nd]

According to the Easier to Read BCD436/536HP Manual in the GPS section, it suggests to "A good application of this feature would be to set the longitude and latitude for each multi-site system transmitter as usually you can receive at least a handful in any given location."

My question: How do you set the longitude and latitude for each site. I can't find it anywhere in the manual for the 436HP nor the Sentinel software. What am I missing? Is it in the database file somewhere? I don't think the database can be edited.

Thanks in advance for you're help on this.

 

[ProScan]

According to the Easier to Read BCD436/536HP Manual in the GPS section, it suggests to "A good application of this feature would be to set the longitude and latitude for each multi-site system transmitter as usually you can receive at least a handful in any given location."

My question: How do you set the longitude and latitude for each site. I can't find it anywhere in the manual for the 436HP nor the Sentinel software. What am I missing? Is it in the database file somewhere? I don't think the database can be edited.

Thanks in advance for you're help on this.

Go into the Sentinel Favorites Editor then click on a Site. You should see a Location tab on the right side.

 

[morrisr3nd]

Thanks so much. That's exactly what I was looking for. Much appreciated.

 

[ProScan]

Thanks so much. That's exactly what I was looking for. Much appreciated.

You're very welcome!.

 

[nessnet]

While you are in there, (location tab), also note the range setting. This is the radius of the GPS circle (estimated RF propagation) of that site. Note that if a simulcast 'site', it'll be the estimated center of ALL the individual transmitters coverage, not any individual one