996p2 tone out question

Status
Not open for further replies.

ryradio

Member
Premium Subscriber
Joined
Oct 28, 2011
Messages
88
I have 6 department stored in my tone-outs... each use the same frequency and each has 2 tones.

When scanning and I want to switch to toneouts, I hit function>SQ and the toneouts appear. They appear to scan between the 6 frequencies.

If I just want to monitor 1 of the 6... is it simply pressing "hold" on the one I want to monitor and the rest would be locked out?

I am unclear after reading the manual as it also says keys can be added to tones.
 

UPMan

Uniden Representative
Premium Subscriber
Joined
Apr 19, 2004
Messages
13,288
Location
Arlington, TX
It will actually hit on any tone-out where all settings are the same except for the tones themselves. If you want to isolate to just one of the tone-outs, change one of the other settings so that all 6 no longer match. You can usually safely set AGC to a different value (IIRC), for example.
 
Status
Not open for further replies.
Top