SDS100/SDS200: Adjustable Steps and RX modes or deprived again?

[stlouisx50]

Looking at the Sds100, but was wondering if there are adjustable Steps when searching. Also wondering about the ability to change recieved modes AM/NFM/FM. Is there WFM? The old scanners you could change all these. Haven't been happy with the Pro668s limits when searching. New scanners seem to add new stuff, but take the nitty gritty good stuff.

I sure hope so, the Pro668 misses so much in the Airband because they didn't program it to search the correct steps rate. I believe this to be true with the above 160mhz-174mhz as well.

 

[GTR8000]

The SDS series has the following modultations and steps available for custom searches:

AM, NFM, FM, WFM, FMB

5.0, 6.25, 7.5, 8.33, 10.0, 12.5, 15.0, 20.0, 25.0, 50.0, 100.0 kHz

This info is in the RR wiki for that model.

 

[stlouisx50]

The SDS series has the following modultations and steps available for custom searches:

AM, NFM, FM, WFM, FMB

5.0, 6.25, 7.5, 8.33, 10.0, 12.5, 15.0, 20.0, 25.0, 50.0, 100.0 kHz

This info is in the RR wiki for that model.

Thanks I wanted to ask specifically about adjustable though. While scanners have all the modes and steps showing in the wiki. I have found while a scanner can do it, does not mean you can self adjust them.

I appreciate it 👍

 

[GTR8000]

Most Uniden scanners have 10 Custom Search ranges where you can set the upper/lower frequency limit, modulation, step, delay, attenuation, etc. for each of those.

Easier to Read SDS100/200 Digital Scanner Manual