This one was found with a pile of junk on a tarp at the Dayton hamfest a few years ago for like $1. The screws were missing from the back and the back was off and sitting to the side. It has some wear but not too bad considering. It had rained so there was a bit of corrosion on the parts on the back PC board. I messed with it and assumed it didn't work but recently checked it out again and found I was wrong. It was just a bit low in sensitivity. I put it on the test set and readjusted the slugs in the receiver which perked it up quite a bit. It also seemed someone had ramped up the output power as far as possible so I backed that down to normal level. I put some new screws in the back. So far it seems to work fairly well. It was also off freq by about 5 kHz but I got it back close as I could (about .5 k off) until I ran out of varicap adjustment.
I was hoping to find the manual to make sure what tuning slugs were what but I guess now that it's pretty much working normally it's not a big deal.
I wish they would have made their other radios similar to this. The case, buttons, and internal connections are of much better design.