G8OEO
Member
Having played around with DSD Plus for some time I decided to try this newly bought handheld Anytone radio for casual listening to local commercial DMR transmissions.
Despite using a good external antenna (signals are pretty strong) and checking that audio was being transmitted simultaneously using DSD Plus I’m having problems getting the handheld to output any DMR audio apart from the occasional short burst of speech.
The Anytone is in VFO mode with the channel set up for DMR repeater operation (with the unused Tx frequency deliberately set over 1MHz higher than Rx ) and Digital Monitor switched ON (Double Slot, Any CC, Any ID, Slot Hold ON).
I also tried it in simplex mode but no luck there either.
I wonder if anyone has managed to use the 868 or 878 successfully for general DMR monitoring.
Despite using a good external antenna (signals are pretty strong) and checking that audio was being transmitted simultaneously using DSD Plus I’m having problems getting the handheld to output any DMR audio apart from the occasional short burst of speech.
The Anytone is in VFO mode with the channel set up for DMR repeater operation (with the unused Tx frequency deliberately set over 1MHz higher than Rx ) and Digital Monitor switched ON (Double Slot, Any CC, Any ID, Slot Hold ON).
I also tried it in simplex mode but no luck there either.
I wonder if anyone has managed to use the 868 or 878 successfully for general DMR monitoring.
Last edited: