APX8500 O3 head install 2020 Toyota Camry

Status
Not open for further replies.

SlipNutz15

Wacker
Feed Provider
Joined
Aug 6, 2005
Messages
633
Location
Central PA
APX8500 installed in the trunk. NMO antenna hole drilled center of trunk and coax routed down trunk arm into trunk to radio brick. Control cable and speaker wire ran down the passenger side. Main power and ignition sense wires ran down the driver side. Ignition sense wire tapped into the fuse block under the dash on driver side. Main power routed through wire grommet in fire wall to engine compartment to battery with in-line fuse at battery. O3 head stored in storage area in center console. Hole drilled in side of storage cubby and then O3 head wire connected to control head extension wire on passenger side of center console. MagMic base secured behind dash. Small dent in dash notes where mic can go when out of storage. External speaker mounted to rear of center console. All wires in trunk and main power wire in engine compartment loomed. Quad band Laird antenna to be used once it arrives.
 

Attachments

  • IMG_6734 (1).jpeg
    IMG_6734 (1).jpeg
    128.1 KB · Views: 507
  • IMG_6741 (1).jpeg
    IMG_6741 (1).jpeg
    108.3 KB · Views: 532
  • IMG_6744(1).jpeg
    IMG_6744(1).jpeg
    150.1 KB · Views: 542
  • IMG_6745 (1).jpeg
    IMG_6745 (1).jpeg
    158.3 KB · Views: 612
  • IMG_6761 (1).jpeg
    IMG_6761 (1).jpeg
    113.4 KB · Views: 611
  • IMG_6773 (1).jpeg
    IMG_6773 (1).jpeg
    194.5 KB · Views: 595
  • IMG_6775 (1).jpeg
    IMG_6775 (1).jpeg
    84.7 KB · Views: 486
  • IMG_6785 (1).jpeg
    IMG_6785 (1).jpeg
    172.8 KB · Views: 469
  • IMG_6786 (1).jpeg
    IMG_6786 (1).jpeg
    190.8 KB · Views: 473
  • IMG_6787 (1).jpeg
    IMG_6787 (1).jpeg
    146.7 KB · Views: 463
Status
Not open for further replies.
Top