Dovebar1
Member
I am looking into building a Bandpass Filter for passibly 20 and 10 meters.
I found some schematics in a vary great
book on electronics titled Experimental Methods ln RF Design.
I refer to page 6.76 and 6.77 2 receiver BPF. I assume they could also be used in lower level stages of a transmitter or transceiver.
My question is on the input end if I want other then 50 ohms, say 1000 ohms how do I know what value to make the c end capacitor?
Any help on this would be highly appreciated.
Thank you, Jim.
I found some schematics in a vary great
book on electronics titled Experimental Methods ln RF Design.
I refer to page 6.76 and 6.77 2 receiver BPF. I assume they could also be used in lower level stages of a transmitter or transceiver.
My question is on the input end if I want other then 50 ohms, say 1000 ohms how do I know what value to make the c end capacitor?
Any help on this would be highly appreciated.
Thank you, Jim.
