BC125AT search question

[airwolfbell222]

I was wondering on the BC125AT if you can

1. Change the modulation mode on on custom or factory programmed searches (ie. NFM, AM, ect.)

2. Change the steps on factory programmed or custom searches (ie. 25 kHz/50 kHz, ect.)

Thanks!

 

[captclint]

I was wondering on the BC125AT if you can

1. Change the modulation mode on on custom or factory programmed searches (ie. NFM, AM, ect.)

2. Change the steps on factory programmed or custom searches (ie. 25 kHz/50 kHz, ect.)

Thanks!

I don't see anything in the manual, but http://forums.radioreference.com/uniden-scanners/239168-bc125at-firmware-update-released.html changes everything to latest step size.

 

[TedRHayes]

Unfortunately there appears to be no way to change the Modulation (NFM/AM) or step size during Service or Custom searches in the BC125AT from the bandplan defined in the firmware.

This is a little frustrating since there is a lot of MILAIR traffic in the 136-142 band in AM mode, but the bandplan defaults to NFM.

One can program a scanned channel (1-500) to a modulation different than the bandplan.

 

[airwolfbell222]

That's what I was afraid of, thanks for the info!

Unfortunately there appears to be no way to change the Modulation (NFM/AM) or step size during Service or Custom searches in the BC125AT from the bandplan defined in the firmware.

This is a little frustrating since there is a lot of MILAIR traffic in the 136-142 band in AM mode, but the bandplan defaults to NFM.

One can program a scanned channel (1-500) to a modulation different than the bandplan.