BC296D Battery Charging Question

Status
Not open for further replies.

FireCop

Public Safety Grunt
Premium Subscriber
Joined
Dec 19, 2002
Messages
331
Location
Statesville, NC
Hello Everyone,

I have a BC296D. I have a new battery for the scanner but do not want to charge the battery in the scanner. I purchased a MAHA MH-C777-Plus II charger to try this. I need some ideas on how to connect the battery pack to the charger. Any help will be appreciated.

Thanks,

Ron
 

dlbrock

Member
Joined
Apr 24, 2005
Messages
147
Location
Russiaville, IN
The easiest way is to take a razor blade and cut two small holes in the plastic battery cover to expose the connection where the wires are soldered to the batteries. You can then set the height and spacing of the pickup contacts and slide the battery against the pickup contacts. If you get an Error 1 then switch the polarity switch on the front of the charger. Also make sure you set the battery type correctly and use the magnetized heat sensor.

If you need any further info let me know.

Regards,

Doug
 
Status
Not open for further replies.
Top