BC780XLT acting weird after WinScan780 programming...

[OpSec]

I programmed all the Talkgroup data I needed and now when the 780 is in trunked list scan, it never leaves list 1...even though I have 4 lists set to scan. If I manual set it to a new talkgroup I programmed, it misses calls 90% of the time on that TG.

What did I do wrong? It scanned the lists just fine before...

 

[AZScanner]

I programmed all the Talkgroup data I needed and now when the 780 is in trunked list scan, it never leaves list 1...even though I have 4 lists set to scan. If I manual set it to a new talkgroup I programmed, it misses calls 90% of the time on that TG.

What did I do wrong? It scanned the lists just fine before...

Which system? Is it type I or II? Or a hybrid? Or EDACS? Any could be a factor. Sometimes Winscan acts....well, strange.

-AZ

 

[OpSec]

There are 2 Type II's and 1 EDACS. I entered some data by hand weeks ago, and all worked great. Now with WinScan, it's being retarded :shock:

 

[AZScanner]

There are 2 Type II's and 1 EDACS. I entered some data by hand weeks ago, and all worked great. Now with WinScan, it's being retarded :shock:

Weird. If you like, post your data file as an attachment and maybe I or someone else here can figure it out. I have Winscan here so I can open the file and see if I notice anything odd in it.

-AZ

 

[OpSec]

Will do...