BC796D and P25 Programming

[oilmillcharlie]

Anyone know how I should program the Pro-796D to Trunk track the following system:

Waterford CT Ma/Com P25 9600Baud

Frequencies: CC854.3875, Voice/Data 858.2375,859.2375, 859.7125, 854.1375, 854.1625.

Base: 851.00625 Spacing: 0.00625 Bandwidth: 0.00625 TX Offset: -45.00000 per Pro96com.

Since the BC796 requires low channel and high channel plus spacing and offset. What would be the correct settings given the above data.

TIA,

B.K.

 

[ka3jjz]

If you're talking about this system, you shouldn't need any base/offsets...

Waterford Public Safety Trunking System, Waterford, Connecticut - Scanner Frequencies

as that information would be carried in the control channel in a true P25 system. However, with MA/Com ??? 73 Mike

 

[oilmillcharlie]

If you're talking about this system, you shouldn't need any base/offsets...

Waterford Public Safety Trunking System, Waterford, Connecticut - Scanner Frequencies

as that information would be carried in the control channel in a true P25 system. However, with MA/Com ??? 73 Mike

Mike,

In order to get it to work on my Pro-96/2096 I had to set it up as multi table 800 Mhz 9600 baud with a lo channel of 0 (zero) and a hi channel of 65535. offset 0 spacing 6.25. Seems to work O.K. Do not understand the proper settings for the BC796 though. As I said before the BC is looking for a lower and upper frequency and offset and spacing. It will not accept the numbers I used in the Pro96.