I am usually "fairly comfortable" with the BCD396T but I am experiencing the following:
When the scanner is operating on HAM Bands (VHF & UHF), I press on [Func + .NO] and I obtain the reverse frequency and signal (if applicable).
However, when I try this in the 410 or 160 MHz (for example), the 396 is displaying " Error No Reverse ".
Is there something I am forgetting in the settings or else ?
Thank you in advance for your response.
When the scanner is operating on HAM Bands (VHF & UHF), I press on [Func + .NO] and I obtain the reverse frequency and signal (if applicable).
However, when I try this in the 410 or 160 MHz (for example), the 396 is displaying " Error No Reverse ".
Is there something I am forgetting in the settings or else ?
Thank you in advance for your response.