BCD396T stops scanning properly

Status
Not open for further replies.

Inssomniak

Member
Joined
Oct 25, 2006
Messages
74
I have this scanner that I use for a RR live audio feed I set up a few weeks ago, and its always on, only scanning a Bell fleet net OPP P25 (2 talk groups).

But today although the scanner had a good lock on the CC and good signal it just stopped seeing any talk group activity.

I couldn't figure it out, but deleting and reloading the scanner in arc396 and the problem was gone.
No changes in the TGs or anything else.

Anyone else seen this? I don't really want to reprogram my scanner every 2 weeks.

Latest firmware.
 

ScanMan055

Member
Premium Subscriber
Joined
Aug 31, 2010
Messages
35
Location
Pemberton, NJ
I would check the following:

Squelch Level, Attenuation, Delay, System Band Plan, System Hold Time, Status Bit set to ignore, End code set to yes, and I-Call set to off unless used in your area. I would have the "bells and whistles" turned off during trouble shooting.
 
Status
Not open for further replies.
Top