I am trying to setup wifi on a 536 for an individual and have hit a wall, with no results. At first when I connected the dongle and attempted to enter the network password it was showing as incorrect. I am confident it was correct.
I have attempted to update the dongle but I am not confident the dongle updated. When I connect the dongle to the 536, I go to Wi-Fi setup, Set Connection, Infrastructure Mode... and receive "AP wasn't detected. Press any key".
I haven't found a lot of direction about the setup. I did read where if you have the wifi dongle connected to the scanner during a firmware update the dongle will update at the same time. My firmware on the scanner is updated and I am running 1.11.29, however the dongle was not connected when I updated the scanner.
I've gone backward here. It didn't work at first, but at least the scanner could see the wifi connection. Now it's not seeing anything.
I have attempted to update the dongle but I am not confident the dongle updated. When I connect the dongle to the 536, I go to Wi-Fi setup, Set Connection, Infrastructure Mode... and receive "AP wasn't detected. Press any key".
I haven't found a lot of direction about the setup. I did read where if you have the wifi dongle connected to the scanner during a firmware update the dongle will update at the same time. My firmware on the scanner is updated and I am running 1.11.29, however the dongle was not connected when I updated the scanner.
I've gone backward here. It didn't work at first, but at least the scanner could see the wifi connection. Now it's not seeing anything.