BCT15X question

[tahoekid77]

I programmed my scanner, everything great but I accidentally enabled one of the 'built in' states (Alabama of course) and now it scans both my custom programming AND the built-in "Alabama" channels.

I can't figure out how to turn off the built in state. (?)

 

[ka3jjz]

You didn't say what software you are using - if any - but the manual way to turn off the BearTracker states is defined at the bottom of;

DMA Scanners and Software - The RadioReference Wiki

from our DMA FAQ in our wiki...best regards...Mike

 

[W8RMH]

Using BearTracker Scanning

Press POL and HP until all the icons (PL, DT, HP, and BT) disappear from the display to turn off all preprogrammed frequencies.

http://marksscanners.com/BCT15X/bct15x.shtml#bt

 

[tahoekid77]

Using BearTracker Scanning

Press POL and HP until all the icons (PL, DT, HP, and BT) disappear from the display to turn off all preprogrammed frequencies.

Easier to Read BCT15-X Scanner Manual

Thanks - that was it. I have the scanner mounted in center console, and sometimes elbow-bump into controls and make it get whacky. I guess I should learn about keylock (if there is one).