How I programmed my BCT8
It took me a week to understand how to program it though. No one has clear instructions. I had N_ALSCAN to talking with me about it. He streams some Huntsville scanner traffic. I could not have figured it out without his help.
First I had to upgrade the firmware because of the Local Public Safety Radio rebanding.The link is on the RR site and the Uniden site.
Next I purchased the ARC8 programming software from scannermaster.
Then upgraded my RR subscription to allow direct downloading from their web service. (It is possible to program all of the frequencies manually). I went the easy route. It only took a week LOL.
Here is the tricky part that no one tells you. *** With the trunked system you desire selected check all the Main talkgroup boxes. Then uncheck the talkgroup and sub talkgroup boxes that you don't want to listen to***. This way you don't miss any of the main talkgroups.
In the trunking tab Ion the ARC8 software I had to select trunking system type (motorola type 2 for me), turn on delay, turn on ignore end signal, and set the tab to plan 2 for the Huntsville Public safety system.
The scanner has to be set to receive remote programming. (press and hold the ( . ) on the BCT8 pick the baud rate. and establish communication with the computer containing the software.
Next upload the data to the scanner selecting all the boxes in the trunking section.
I hope this helps you