OneBadUukha
Member
The Uniden BCD996P2 users guide states the following on page 77:
To start Band Scope mode Hold on and channel and Circle key (function button), then 3 (Srch 3) to start Band Scope mode at the frequency you held at.
As such, I waited until my scanner landed on a channel of a conventional system with a good signal. I then:
- pressed the Hold/Resume button to Hold it. One beep
- pressed the Function Key. One beep
- pressed the 3 (Srch 3) key on the number pad. Three quick beeps
All I get is the three quick beeps. Nothing happens. Can anyone tell me what I'm doing wrong? Thanks!
To start Band Scope mode Hold on and channel and Circle key (function button), then 3 (Srch 3) to start Band Scope mode at the frequency you held at.
As such, I waited until my scanner landed on a channel of a conventional system with a good signal. I then:
- pressed the Hold/Resume button to Hold it. One beep
- pressed the Function Key. One beep
- pressed the 3 (Srch 3) key on the number pad. Three quick beeps
All I get is the three quick beeps. Nothing happens. Can anyone tell me what I'm doing wrong? Thanks!