hello and good day folks
I have a project i have been working on .
I have a commandStar light i am wanting to use for local control of a cdm1550, a desktrac and a few of the channels i will use for rx only.
i have managed to figure out the programing of the console somewhat. anf i have managed to connect 2 scanners to the 25 pair cable via the configuration report.
my issue is the local remote controll part of the cdm and the desktrac.
not sure if i need a tone remote adapter since the radios are in the same room. i found the correct wiring diagrams but when i do the connections and try the ptt button on the console with the correct channel selected the radios dont respond to the ptt. am i on the right track?
I have a project i have been working on .
I have a commandStar light i am wanting to use for local control of a cdm1550, a desktrac and a few of the channels i will use for rx only.
i have managed to figure out the programing of the console somewhat. anf i have managed to connect 2 scanners to the 25 pair cable via the configuration report.
my issue is the local remote controll part of the cdm and the desktrac.
not sure if i need a tone remote adapter since the radios are in the same room. i found the correct wiring diagrams but when i do the connections and try the ptt button on the console with the correct channel selected the radios dont respond to the ptt. am i on the right track?