• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

communications trailer antenna mount in top

Status
Not open for further replies.

vsp5151

Member
Joined
Jan 21, 2006
Messages
99
We have small trailer we are fixing up for an amateur communications trailer. We would like to have two 1/4 wave antennas on top, one for UHF and one for VHF. These would be temporary use antennas typically used after you get to where the trailer is needed until better antennas could be deployed. There is no headliner in trailer, the aluminum top is easily accessible. Would a NMO mount work in this thin aluminum? We even discussed backing the inside of the trailer top with a piece of thin metal just to provide extra strength. Would this mount work or is there a better mount we can use for thin aluminum.
 

mmckenna

I ♥ Ø
Joined
Jul 27, 2005
Messages
23,615
Location
Hiding in a coffee shop.
Adding some rigidity under the aluminum should be pretty easy. Since the area will be dry inside the trailer, regular sheet metal would work fine. You can get that in various gauges from most hardware stores. Trick will be securing it. Not sure I'd trust glue or any other adhesive due to heat coming through the roof. If there's any frame work to support the roof, work with that.

A standard NMO would work just fine. If you wanted to get fancy, they make NMO mounts with an "N" connector on the underside.
 

jeepsandradios

Member
Feed Provider
Joined
Jul 29, 2012
Messages
2,005
Location
East of the Mississippi
As others said a NMO mount is fine. I helped with multiple SAR trailers in NY and all have some variant of an NMO. The 3"8" is better in my opinion as its a simple hole. I actually found that a 4x4 outlet box cover plate works perfect on the inside to help with making it rigid. I have used a fender washer in a pinch also.
 

K4RBT

Member
Joined
May 12, 2011
Messages
91
They do this in aircraft with its thin skin, it is called a "doubler plate", only problem is they rivet the skin and plate together. If you are near an airport with a FBO, check with them to see if there is another way to mount the plate. For honeycomb panels like on helicopters, it is done differently.
 
Status
Not open for further replies.
Top