Control Channel only on Phase 2?

Status
Not open for further replies.

ka3jjz

Wiki Admin Emeritus
Joined
Jul 22, 2002
Messages
25,361
Location
Bowie, Md.
I don't think I've ever seen this asked, so here goes...

I know that Control Channel Only is the default when programming Phase 1 trunks in Uniden scanners. But how about Phase 2? Does it work the same way? I suspect not, only because not only is the frequency involved, but the slot as well. Or is that written into the control channel as well?

Mike
 

GTR8000

NY/NJ Database Guy
Database Admin
Joined
Oct 4, 2007
Messages
15,414
Location
BEE00
I don't think I've ever seen this asked, so here goes...

I know that Control Channel Only is the default when programming Phase 1 trunks in Uniden scanners. But how about Phase 2? Does it work the same way? I suspect not, only because not only is the frequency involved, but the slot as well. Or is that written into the control channel as well?

Mike

No difference. The control channel provides all necessary information.
 

ka3jjz

Wiki Admin Emeritus
Joined
Jul 22, 2002
Messages
25,361
Location
Bowie, Md.
But is CCO the default when programming a phase 2 system, like it is on phase 1? Mike
 
Status
Not open for further replies.
Top