localknitwits
Member
Hello, BCT15X
Playing around with my new scanner.
I programmed 2 systems.
1 conventional (1 channel)
1 trunking (Motorola) (1 tgid).
The display stays on the trunking system for approximately 3 seconds then displays the conventional channel for less than a second and goes back to the trunking system (repeat all over again) when there is no activity. If there is activity on either system I pick it up immediately.
Is this normal? Why does the display show the trunking system longer than the conventional system when scanning? Everything works, just wondering why the longer display. Thanks.
Playing around with my new scanner.
I programmed 2 systems.
1 conventional (1 channel)
1 trunking (Motorola) (1 tgid).
The display stays on the trunking system for approximately 3 seconds then displays the conventional channel for less than a second and goes back to the trunking system (repeat all over again) when there is no activity. If there is activity on either system I pick it up immediately.
Is this normal? Why does the display show the trunking system longer than the conventional system when scanning? Everything works, just wondering why the longer display. Thanks.