SDR# DSD decoder receiving data but no output

afilman

Newbie
Premium Subscriber
Joined
May 3, 2020
Messages
4
I have been playing around with this for a while, checking forums and watching videos. I finally have to make my own post. It looks like DSD is doing something as CMD has data coming through it, but the event log doesn't show anything. I am not able to hear anything unless I check "Enable aux audio output" in the DSD plugin and even then it is all just static sounds as if I just listened to the frequency on SDRsharp. I tried adjusting RF gain and audio gain thinking that might help but I am not getting anything. I am a firefighter and have some familiarity with this frequency so I know this is a busy channel. My only guess is that this is a trunking channel and could cause DSDplus to not properly decode, as I only have one RTL-SDR. Any input would be greatly appreciated.
 

Attachments

afilman

Newbie
Premium Subscriber
Joined
May 3, 2020
Messages
4
Great, thanks for letting me know that. Sounds like I need to do some more research with system type.:)
 

afilman

Newbie
Premium Subscriber
Joined
May 3, 2020
Messages
4
Using unitrunker I was able to identify a frequency that was being used and not listed in a database that I could find. I tuned in immediately and was able to get voice off of it. You helped me out a lot.
 
Top