DSDPlus DSDPlus 2.547 not decoding NXDN radio Aliases

[Tim]

Greetings...

I have purchased a new laptop and just downloaded the above version. I am able decode the P25 radio aliases with relative no problem. While decoding a NXDN-48 system while tracking the control channel, I do not get any radio aliases like I did on the Fast Lane system (Which was an older version than the latest public release). However, while parked on one of the frequencies of the system, I get all the ID aliases with no problem. Anyone also having/had this issue? Any solutions?

Tim

 

[wx5uif]

Do you have it following the voice channels? Alias on NXDN is only sent on the voice channels.

 

[u2brent]

Recently discussed here as well.

DSDPlus - NexEdge Radio ID's not updating DSDPlus.radios

DSDPlus 2.523 (Most Recent FastLane version) 2 - RTL-SDR v3 Radios Windows 11 Pro I run a dual radio setup, with one running as the dedicated CC monitor, and the second for VC following. I've been going through a bunch of recordings and trying to identify talkgroups on a rather large (20+ site)...

forums.radioreference.com

 

[Tim]

I am using the Fast Lane version 2.523 and monitoring a NXDN system right now. I do receive radio aliases on the system. I am only using one dongle, which is parked on the control channel. It seemed like to me the above referenced article was receiving aliases, but wasn't storing them.

I was just wondering if there was a setting I messaged up or somehow got wonky. The "Decode" area is showing that is decoding all types of systems so its not that.

Tim

 

[dave3825]

Why not use single dongle mode and let it follow the calls onto the voice channels where you will likely acquire the aliases?

 

[Whiskey3JMC]

I am using the Fast Lane version 2.523 and monitoring a NXDN system right now. I do receive radio aliases on the system. I am only using one dongle, which is parked on the control channel. It seemed like to me the above referenced article was receiving aliases, but wasn't storing them.

I was just wondering if there was a setting I messaged up or somehow got wonky. The "Decode" area is showing that is decoding all types of systems so its not that.

Tim

"Parked" on the control channel how? Are you piping audio through a VB audio cable to DSDPlus & using another SDR app as host rather than using your SDR's applicable FMPx.bat to follow the system?