DV1 Manual Programming going to BuTel

[DSC45]

Hi!

Purchased BuTel Software for my AR-DV1. Up until now I've programmed each channel manually. Looking for the step by step procedure in the manual and unable to find results.

Can someone please help me, Using BuTel I've designed three banks to install in the receiver. Would you advise the step by step procedure from BuTel in the PC transfer to the DV1?

Thanks in advance for your help!

 

[Butelsoftware]

In ARC DV1 click the Send button in the toolbar to upload data to the DV1.

Gommert
Butel Software

 

[DSC45]

In ARC DV1 click the Send button in the toolbar to upload data to the DV1.

Gommert
Butel Software

Hi Gommert,

I connect the BNC cable from PC to DV1. Correct?

Do I have to push the ENTER button on DV1 before the SEND button?

 

[Butelsoftware]

You need to connect the USB cable and install the driver. Software will put the DV1 in remote mode. See section 1.3 of the manual.

Gommert
Butel Software

 

[DSC45]

You need to connect the USB cable and install the driver. Software will put the DV1 in remote mode. See section 1.3 of the manual.

Gommert
Butel Software

Gommert, Thanks very much!