RadioReference.com Forums
I am using Etrunker 3.8.3 version and with one slicer I have some of the "groups" are showing up as "patches". Yet switching to a different slicer they are showing up as groups. This is on the same system / same control channel at the same time.
It should be noted that in the first case not all the groups in that system are shown as patches on the system, just some. All of the data appears accurate, such as the id's of the radios etc. The program is showing 100% accuracy.
At the same time .. it has been determined that someone else with a different slicer is seeing them as groups.
Is there anything in the slicer that should be making this strange behavior ? (It just started happening a few weeks ago)
Any ideas would be appreciated ..
It should be noted that in the first case not all the groups in that system are shown as patches on the system, just some. All of the data appears accurate, such as the id's of the radios etc. The program is showing 100% accuracy.
At the same time .. it has been determined that someone else with a different slicer is seeing them as groups.
Is there anything in the slicer that should be making this strange behavior ? (It just started happening a few weeks ago)
Any ideas would be appreciated ..