Finding control channel

Status
Not open for further replies.

nd5y

Member
Joined
Dec 19, 2002
Messages
11,228
Location
Wichita Falls, TX
It is scanning the frequencies you programmed for that particular system looking for a control channel.
If that suddenly happens it means that the control channel changed to one that is not programmed and the scanner can't find it.
 

SCPD

QRT
Joined
Feb 24, 2001
Messages
0
Location
Virginia
OK thanks. That's what I thought. I wasn't sure if it only looked at the frequencies programmed for the system or looked at some other method and determined it should be the one. Im my case the cc changed but is too weak a signal to be detected.
 
Status
Not open for further replies.
Top