amcare38
Member
I'm trying without success to program a Tone Out Search. Only information I don't have is the A & B tones. I've followed the directions but it doesn't capture anything. What am I doing wrong?
Fire Tone Out
- Thread starter amcare38
- Start date
- Status
doctordialtone
Member
Double posting for one...
Didn't you ask this earlier?
BCD536HP Tone Out
I'm trying without success to program a Tone Out Search. Only information I don't have is the A & B tones. I've followed the directions but it doesn't capture anything. What am I doing wrong?
Try this:
BCD436/536HP Digital Scanner Manual Tone Out
You’ll need those tones for it to work
Eng74
Member
If you are searching for the tone pairs set both A and B to 0. Set the delay time to Infinite so you will be able to see the tones. Then put into standby and wait for a tone out.
Or use something like PROSCAN to log the tones and you have a paper trail to go by.
amcare38
Member
Still can't get the Tone Out operating. I've followed the instructions in both the uniden & easier to read manuals but if the scanner is scanning or held on the Tone search/stand by mode nothing is received however if I hold on the frequency in my favorites list I hear everything.........
It only works if the scanner is locked on the frequency in the tone out mode.
Eng74
Member
Maybe they are on an older 2+2 tone out system.
amcare38
Member
Eng74
Member
There are still some older quick call systems that use a 2+2 there are actually 4 tones that go out it sounds the same over the air as a 1+1 because they are so close together.
amcare38
Member
To my knowledge it's not a 2+2 system
Your answer is here it works I have used it.
- Status
Similar threads
BCD436HP/BCD536HP:
Whitelist Unit IDs?