AR-DV10 Firmware 1810A Update Stuck (Won't boot)

Status
Not open for further replies.

gastonet

Newbie
Joined
Mar 1, 2012
Messages
4
Location
Ciudad de Buenos Aires, Buenos Aires
Hello everyone. Tried to update from 1807A to 1810A and the DV10 became unusable.

This is what the screen shows:

AR-DV10
Start
1807A

! FPGA:SD_ONLY !

Err:1601,00402

If I try to update it using the "tool" it recognizes the receiver, the SD and the firmware inside the SD but text becomes red when hitting the update button.

Any idea? (Screenshot and photo attached)

Many thanks in advance.

Gaston.
 

Attachments

  • photo_2018-11-28_16-23-40.jpg
    photo_2018-11-28_16-23-40.jpg
    57.1 KB · Views: 313
  • aorsoft.jpg
    aorsoft.jpg
    52.1 KB · Views: 303

c0ne

Member
Joined
Jun 8, 2018
Messages
254
After a failed attempt to update firmware, remove the battery for a minute or so, then put it back, connect the DV10 to the PC and proceed with the update again using the AOR tool.

This seems to be the general solution to get rid of the error codes.
 

oceans777

Listener
Joined
Jun 3, 2004
Messages
210
Location
Atlanta, GA
I had exactly this same error trying to update mine to 1810A using the SanDisk Ultra 32 GB over the weekend. It failed at the second block at the bottom of display during the update with the same error codes. Glad to see yours reset too.
 
Status
Not open for further replies.
Top