saf47
Member
I was trying to update the firmware for my (new to me) bc346xt and all seemed to be going well when I got a message that said "Programming Error *connect scanner to PC using standard PC interface cable *keep your scanner connected to external power source on the scanner*"
Now when I ran BC_VUP it instructed me to remove the batteries and push L/O and 6 while plugging in the external power which I did. The blank screen lit up and everything looked fine and then I got that message. I checked the ports and connection speeds on both the computer and the scanner. I just can't figure out the problem. The scanner does hook up and communicate no problem with Freescan.
Anyone have any suggestions.
Thanks
Now when I ran BC_VUP it instructed me to remove the batteries and push L/O and 6 while plugging in the external power which I did. The blank screen lit up and everything looked fine and then I got that message. I checked the ports and connection speeds on both the computer and the scanner. I just can't figure out the problem. The scanner does hook up and communicate no problem with Freescan.
Anyone have any suggestions.
Thanks