FreeScan Unhandled exception

[Trixter]

I have used Freescan for sometime now and used it to program my 996xt and 996t. I have been getting this error message during the Virtual Scanner on my Windows 7 and Xp machnes.

Unhandled exception has occurred in your application.

The details show an System overflow exception: Arithmetic operation resulted in an overflow.

Plus the VS will just stop and I have to click the link on to have it start up again.

I tried downgraging FS from H to F and same result. I seem to only get this on the XT and not the T.

Both have the latest firmware and I redid the files and did a total reset on the scanners just to make sure.

I have included a screen shot of the message.

Thanks for the help and great software

 

[cpuerror]

Check to make sure you have that control channel output mode set to off on the scanner.

 

[Trixter]

OK, turned it off and trying it right now, scanning and logging right now, always happened in the first couple of minutes and seems to be working just fine, thank you. Will post if anything changes.

 

[Trixter]

Everything works great. Have had zero problems. Many thanks cpuerror.

 

[K4NNW]

I got the same message when I tried this for the first time. Control Channel output is off in my scanner right now, too.