frequency issue on HP2

Status
Not open for further replies.

mapa2

Member
Premium Subscriber
Joined
Nov 11, 2016
Messages
4
One frequency I sometimes monitor, sheriff's freq (Linn County Oregon) comes in loud and clear on 155.595 on both of my other scanners (both analog). I did not see it in RR database, so manually entered it in Sentinel. It will sometimes stop, but no audio. Ran both other scanners at the same time, and they both had audio on this frequency I'm sure I missed a step somewhere, any ideas?

Note: there are 2 frequencies for this agency, but the other one is weak. 154.710
 

phask

Member
Premium Subscriber
Joined
Dec 19, 2002
Messages
3,117
Location
KZZV - SE Ohio
Those show as the repeater INPUT freq. - they would not be in the DB. If correct you are probably not hearing 100% with your other scanners.

FWIW - stock HP antenna is far from the best. Might try swapping and see if there is any improvement - but it also seems you need improvement to actually her the repeater output with all your radios.

look here

155.595 Search Results




One frequency I sometimes monitor, sheriff's freq (Linn County Oregon) comes in loud and clear on 155.595 on both of my other scanners (both analog). I did not see it in RR database, so manually entered it in Sentinel. It will sometimes stop, but no audio. Ran both other scanners at the same time, and they both had audio on this frequency I'm sure I missed a step somewhere, any ideas?

Note: there are 2 frequencies for this agency, but the other one is weak. 154.710
 
Status
Not open for further replies.
Top