Frequency setting in CHIRP software ...

[rrnewuser]

I am beginning to use the CHIRP software and am confused by the "memories" entries ...

I am trying to input this repeater spec:


TX 467.5000, RX 462.5000, PL TX 127.3, PL RX None


(which makes perfect sense to me ...)

However, in the CHIRP "memories" interface, there is only a single entry for "frequency" ... I cannot input a TX freq and a RX freq independently ...

What am I missing here ?

Thanks.

 

[Kb2Jpd]

Most bandplans use a specific offset. In your case you enter the RX frequency then it will ask for positive offset you make sure it has +5 MHz. It should work then.

Adam Kb2Jpd


Sent from my iPhone using Tapatalk

 

[SpugEddy]

Yes look to the right of the frequency and you
will see "Offset" column. Set how much your offset
should be. In the Duplex" column, set your shift to + or -

In your case, for the repeater
Program the repeater's output frequency in the Frequency column 462.500
Then set your offset to 5.00000 in the Offset column (Now you will transmit on 467.500)
Then set the shift to + in the Duplex column (462.500 + 5.000 = 467.500)

 

[nd5y]

MemoryEditorColumns - CHIRP
Read all of it. Pay attention to the Duplex and Offset columns.

 

[rrnewuser]

Thank you very much - appreciated.

 

[shanefawks]

New to the boafeng 50x2

Hi i am trying to put in a input frequency for my fire repeater 154.13000 I can find it on the chirp software what am I missing thank u

 

[nd5y]

Hi i am trying to put in a input frequency for my fire repeater 154.13000 I can find it on the chirp software what am I missing thank u

Read the link in post #4 in this thread. It tells you how.