an39511
Member
I have two BCD536HP radios and one of them when I set the GPS serial baud rate to 115,200 bps it will not retain that setting when I power cycle the radio. It keeps defaulting back to 4800 bps. The other radio holds the setting. Both radios have the same firmware.
Also, I have sentinel configured to set the GPS baud rate to 115,000 bps but it does not seem to work either.
Again, this problem only happens on one of my units. Any Ideas?
Also, I have sentinel configured to set the GPS baud rate to 115,000 bps but it does not seem to work either.
Again, this problem only happens on one of my units. Any Ideas?