Harris XG-100P MSCommNet Band Plan

[8859]

Good Morning - looking for assistance with the Band Plan for MSCommNet. The below is what I am programming, but I am only hearing very intermittent communication and often only one side of the conversation. I've tried going off previous posts on the subject and not able to figure it out. Thanks in advance!

Maine State Communications Network (MSCommNet) Trunking System, Statewide, Maine

 

[northstarfire0693]

IDEN table is wrong. Zero out 8,9,10. 1,2,3 look correct, other then the TX offset. Also BEE00 is incorrect. Should be 92751. BEE00 is Moto. Maine uses a Harris system.

Also where are you located in Maine ? You may need to add more towers.

 

[8859]

Thank you - I changed the table, having trouble finding the TX offset. I updated BEE00 to 92751.

Located in Southern Maine. I added all the channels for the specific tower located nearest my location, which is Ossippee.

 

[northstarfire0693]

RFSS ID is also wrong. Needs to be HEX format.

 

[northstarfire0693]

I made some changes to the MP you sent me. You had a lot of errors in it. Give that a try and let me know how it works. Also get into the help menu in RPM. It is loaded with information. You did a decent job at 95% of the programing. Remember to always seek help if you are not 100% sure on what you are doing before you program the radio and turn it on. One little mistake can cause your radio to try and register with the system. If it does, it is flagged and you could face some legal actions. Also the system admin can and will inhibit your radio. FYI there are a lot of system admins on this forum. They are good people. So ask for help first before taking a chance.

 

[mainefisherman207]

So what should the correct IDEN set look like for this system i am also trying to do it

 

[northstarfire0693]

So what should the correct IDEN set look like for this system i am also trying to do it

With what radio ?

 

[mainefisherman207]

With what radio ?

The Harris xg 100p

 

[kg4icg]

Looks like the channel plan is in the wiki page

 

[mainefisherman207]

Looks like the channel plan is in the wiki page

I seem to only be getting bits and pieces

 

[northstarfire0693]

I seem to only be getting bits and piec

The IDEN table is the correct one in wiki unless there has been a change I dont know about.

 

[northstarfire0693]

Just an update. I just came back from a trip in Maine. The IDEN table listed in wiki is correct.