While driving around today I realized I hadn't heard any thing for a while. Touched screen at "MUTE" to check if it had been inadvertantly touched. It is not red. It does turn red for 30 sec then goes back to white like normal. Checked volume and brought up to max and then turned squelch down to no bars. Nada. Hit MUTE a couple of more times and screen went black and system rebooted. This happened several more times with no audio. Put unit on local wx channel but no audio. Opened up units battery cover, removed batteries ( external power and GPS & ant disconnected ) cycled power switch and then and hit reset. Reloaded batteries and plugged external power back in. Hit on, unit did normal start up and still no audio. All service types lit after reset, reduced to normal settings of Law and Fire dispatch und went back to two bars of squelch and unit scans and stops and resumeson usual channels but still no audio.
At time this started unit is plugged into 12vdc, gps plugged in and powered up and antenna is external mag mount. Both unit power and GPS are powered off a common 3 cig lighter acc plug.
Firmware Version: 2.02
Database Ver: 02/19/2012
Help version: 12/07/2011
ESN: yada yada -0A3
Extreme Upgrade
Any ideas or does a trip to Uniden Service department seem to be in its future?
TIA
Ronzo
At time this started unit is plugged into 12vdc, gps plugged in and powered up and antenna is external mag mount. Both unit power and GPS are powered off a common 3 cig lighter acc plug.
Firmware Version: 2.02
Database Ver: 02/19/2012
Help version: 12/07/2011
ESN: yada yada -0A3
Extreme Upgrade
Any ideas or does a trip to Uniden Service department seem to be in its future?
TIA
Ronzo