How do you resume scanning an existing site? (UniTrunker)

[mk262]

I feel stupid asking this but clearly I'm too dense to figure it out. I've successfully pulled a bunch of data off several trunked systems in my county. However, I don't know how to go back and resume looking at a site. When I change the receiver mode to running again it always creates a new system entry.

What is the proper sequence of things I need to do to resume them?

I've looked on the unitrunker guide but didn't see the answer.

 

[SCPD]

EDACS does not broadcast data that can distinguish one system from another.

When the site window appears, the active control channel will display a label that reads "Frequency needed!".

Click on the frequency cell, type F2, and type in the current control channel frequency. The program will match the site number, LCN and frequency to a previously logged site. If a match is found, the program will switch to that site.

For some receivers, the program pulls the active frequency directly from the radio but you can also do this manually.

 

[mk262]

Bingo, thank you so much.