How do you wire a broadband Amplifier?

Status
Not open for further replies.

rbm

Member
Joined
Jan 25, 2005
Messages
1,395
Location
Upstate New York
Along with the article Bruce pointed out, you can use an arrangement like the one below.
I've used this to demonstrate a preamp at a friend's home.
Total price, less the wall wart was around $15

You just need to add another power 'inserter' at the top to get the DC from the coax.

But I would add a DC Block prior to the preamp just because I don't trust the power inserter to block all DC.

Rich

 

Pyr8

Member
Joined
Jan 30, 2006
Messages
36
Location
Mandalore system :|]
Thanks Rich!

Now what happens if you are using a "lightning arrester" off the mast before the line comes into the shack. Will the arrester allow the DC to pass through the line, or will it cause issues?



I'm pressed for time right now so this is a little messy but it should give you the general idea.

Rich

 

rbm

Member
Joined
Jan 25, 2005
Messages
1,395
Location
Upstate New York
What is the model number on the Mini-Circuits you are using in the photo?
Cant quite make it out from the photo.

It's a ZQL-1900MLN.
I use that type for 400-2000 MHz coverage

I just grabbed that one to take the photo.

A lightning arrester 'should have no effect' on the signal.

You should be able to click on the magnifying glass in the bottom right corner of that image a few times to get to the high resolution image.

Rich

ZQL-1900MLN frequency plot
 
Status
Not open for further replies.
Top