how to enter just one frequency

[mrscanner2008]

Hi

I'm new with unitrunker, and i just want to know how to enter just 1 new blank channel, i tired to click on the plus sign but do nothing, I want to enter only a frequency not a complete system.

thanks
Mrscanner2008

 

[K8TEK]

Why? All frequencies need to be in there, it is kind of how UniTrunker works. You don't monitor all frequencies, just the control channel.

 

[mrscanner2008]

I want to enter just 1 frequency because i think i found a new system, and for the moment i have only the control channel frequency, so i would like to enter that frequency in unitrunker and find more infos about this system.

Mrscanner2008

 

[K8TEK]

I want to enter just 1 frequency because i think i found a new system, and for the moment i have only the control channel frequency, so i would like to enter that frequency in unitrunker and find more infos about this system.

Mrscanner2008

Don't enter any frequency, let UniTrunker run and the new system will pop up. Simply entering the frequency in UniTrunker isn't going to do anything, you need the SYSID and UniTrunker will tell you that if it isn't already in there.

 

[mrscanner2008]

so if i understand well : just lets the scanner hold on the frequency i want to decode and start unitrunker and it will find the infos i want?

I will try this.

thanks K8TEK


Mrscanner2008

 

[K8TEK]

It will start a new system and should allow you to enter the frequency then.

 

[K8TEK]

If you really have the urge to add just one channel, you need to start a new system, start a new site and add the frequency under the site, not under the system.

 

[mrscanner2008]

thanks for the infos, i will try that.

Mrscanner2008