Hello. I have a HT1000 UHF. It is currently programmed so that:
A - scans "scan list"
B - plays traffic on channel selected
C - program scan list (no light---doesn't scan, green light---scans, red light---priority channel).
I have the channels I want to be scanned already programmed and everything. However, if I move the channel selector knob while it is playing traffic in "A" mode...it starts to beep with every click of the channel selector.
Afterwards...I turn it to "B"...and turn the channel selector knob. There is no beeping when I turn the channel selector knob except on Channel 3....or Channel 2.
Why it it doing this?
After I turn off the radio and turn it back on and flip through the channels in "B" mode.....it stops beeping everytime it goes to channel 3 or 2 (depends).
any suggestions?
A - scans "scan list"
B - plays traffic on channel selected
C - program scan list (no light---doesn't scan, green light---scans, red light---priority channel).
I have the channels I want to be scanned already programmed and everything. However, if I move the channel selector knob while it is playing traffic in "A" mode...it starts to beep with every click of the channel selector.
Afterwards...I turn it to "B"...and turn the channel selector knob. There is no beeping when I turn the channel selector knob except on Channel 3....or Channel 2.
Why it it doing this?
After I turn off the radio and turn it back on and flip through the channels in "B" mode.....it stops beeping everytime it goes to channel 3 or 2 (depends).
any suggestions?
