I need a new case for my rs pro-97

Status
Not open for further replies.

1979lee

Member
Joined
Jun 24, 2005
Messages
367
Location
bakersfield, california
ok , iam in need of a new case for my old pro97
does anyone know if there still availble?
i found this parts list on another scanner site
thanks

"available RSU parts"

11318532 DIODE 1N4002 RECT 600V.1A SI $.29 In Stock
10514404 XSTR 2SC4226(R24) SI NPN $2.87 In Stock
11449626 XSTR 2SC4116 SI LO PWR AMP NPN $2.49 In Stock
11840212 XSTR SI DIGITAL PNP/NPN $2.49 In Stock
10539476 ANTENNA,RUBBER 15.8CM $10.99 In Stock
10570166 FILTER,CERAMIC 455KHZ $7.18 In Stock
12357562 CRYSTAL 12.75MHZ $9.49 In Stock
12357570 CRYSTAL 20.945MHZ $8.13 In Stock
12357687 CRYSTAL 12.288MHZ $11.11 In Stock
12430674 COVER BATTERY $3.29 In Stock
12430658 HOLDER ASSY BTRY RECHRG $4.69 In Stock
12430666 HOLDER ASSY BATTERY $4.49 In Stock
12418273 CLIP BELT $3.29 In Stock
12418349 REFLECTOR LCD $2.49 In Stock
12430682 KEYTOP $5.99 In Stock
10720209 JACK,ANTENNA $8.29 In Stock
11840063 JACK,EARPHONE $2.87 In Stock
12228714 JACK POWER $2.49 In Stock
12430690 KNOB SQUELCH $2.49 Not In Stock
12430708 KNOB VOLUME $2.49 Not In Stock
12430617 LED FY1112H-1-TR(D OR E) $2.49 In Stock
12430716 LCD $23.49 In Stock
12430724 MANUAL USERS 20-527 $4.99 In Stock
10881886 IC,NJM2904M LINEAR 8 PIN (S) $2.49 In Stock
10894061 IC,74HC4066F 14 PIN $4.84 In Stock
12100327 IC TK11819M SO6S SMT $4.87 In Stock
12106522 IC KA3361BD SO16S $5.99 In Stock
12357596 IC HD74AC164T SMT $4.62 In Stock
12410775 IC SMT TMP93PS44F $54.99 In Stock
12430583 IC SMT MB15F07SLPFV1-G-BND $16.49 In Stock
12430609 IC SMT EEPROM HN58X24512FPI $17.99 In Stock
12429163 POT VOLUME 50K OHM $15.89 Not In Stock SQUELCH 10K OHM
11717485 SPEAKER 8-OHM 500MW $11.89 In Stock
12430591 PCB ASSY LOGIC $81.29 In Stock
12430625 PCB ASSY RF $27.99 In Stock CONSISTS OF: PCB ASSY RF CHASSIS TOP ESCUTCHEON TOP JACK ANTENNA PM 2X4 NI OR BLK SCREW
12430633 CASE ASSY FRONT $19.29 In Stock NON REPAIRABLE
12430641 CASE ASSY REAR $12.69 In Stock NON REPAIRABLE
 

1979lee

Member
Joined
Jun 24, 2005
Messages
367
Location
bakersfield, california
thanks for the reply, yup thats A case, and a nice one too, but not the CASE is was refering too, the one i want is the case ( plastic body of my pro 97) its pretty ugly looking, the thing works great but looks bad, you know i might give your case a try, it might be easyer to get than the one i want


thanks
 
Status
Not open for further replies.
Top