Hello Everyone,
I am having some issues reprogramming my station's base radio. It is an Icom IC-F1721D with the dial. I am able to read/write and do most things with no problem, I'm sure most of this is just operator error.
The first issue is getting the scan to work! I have 3 zones, in zone 1, all channels are in scan list 1, the channels I want scanned have "Inc" selected. however, when I press the P1 button I have programmed for "Scan A Start/Stop", it only says "SCAN1". The radio does not pick up any other channel but the channel it is on. All zones are set up with this same scheme and all have the same issue.
The second issue is with programming an analog channel with CSQ. I am trying to program interoperability channels with receive tone of CSQ. when I dial to a channel with that setup, It is open squelch. Is there a way to change this to tighten the squelch?
I am having some issues reprogramming my station's base radio. It is an Icom IC-F1721D with the dial. I am able to read/write and do most things with no problem, I'm sure most of this is just operator error.
The first issue is getting the scan to work! I have 3 zones, in zone 1, all channels are in scan list 1, the channels I want scanned have "Inc" selected. however, when I press the P1 button I have programmed for "Scan A Start/Stop", it only says "SCAN1". The radio does not pick up any other channel but the channel it is on. All zones are set up with this same scheme and all have the same issue.
The second issue is with programming an analog channel with CSQ. I am trying to program interoperability channels with receive tone of CSQ. when I dial to a channel with that setup, It is open squelch. Is there a way to change this to tighten the squelch?