• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Icom F210 after clone display just flashes

Status
Not open for further replies.

Cs38614

Newbie
Joined
Aug 11, 2010
Messages
3
hello,
After cloning my 210 the display just flashes and nothing works

heres the frequency I've used

451.787500
468.587500

anybody have any ideas?

thanks
 

Cs38614

Newbie
Joined
Aug 11, 2010
Messages
3
Yes that's what it says in the manual. I seen a few frequencies in the radio and deleted them would that have caused this ?
 

rescuecomm

Member
Joined
Jun 20, 2005
Messages
1,005
Location
Travelers Rest, SC
I accidently loaded a VHF program into my Icom F4061 UHF and got a flashing display. You apparently have loaded an out of bandsplit program as Cs suggested. Try reloading the old program.

Bob
 
Status
Not open for further replies.
Top