va7rc
Member
has anyone tried to use an Rlc1 controller on this repeater?
the problem I am having is pin 17 on the db25 on the repeater is called busy and is active low (default)
when I try and use this output to control cor it is pulsing, causing the repeater to keep dropping then coming back up. (heard just as a tic on the repeater output freq) also if you have a courtesy beep programmed in the controller it is going off continously. some of the pins of the db25 on the repeater are programmable with the software but no option for selecting "COR" , was thinking of looking for a proper cor in repeater and bringing it out using one of the unused pins on the db25?
any ideas would be greatly appreciated.
Warren
the problem I am having is pin 17 on the db25 on the repeater is called busy and is active low (default)
when I try and use this output to control cor it is pulsing, causing the repeater to keep dropping then coming back up. (heard just as a tic on the repeater output freq) also if you have a courtesy beep programmed in the controller it is going off continously. some of the pins of the db25 on the repeater are programmable with the software but no option for selecting "COR" , was thinking of looking for a proper cor in repeater and bringing it out using one of the unused pins on the db25?
any ideas would be greatly appreciated.
Warren