Hi all,
Couldn't find this discussed in the forums (searching is hard when one of the words is too short for the search engine and the other is fairly ubiquitous around here), so I'm going to post here.
I am trying to run ID Tracker on a laptop, an HP model 7010ca, running XP SP2 on 2gb RAM and a 60GB HD. It has no com port, but a Belkin USB2.0-to-serial adapter has done the task masterfully for years, handling the programming and monitoring of many of my radios over the RS232 connection.
The radio in question is a Uniden 796D. The baud rates are set the same in the program, the scanner, and Windows; the right COM port (2) for the adapter emulator is set; but every time I try to run ID Tracker it barfs on me. Here's what I get:
- The screen does the typical things ID Tracker does (I've had it run successfully on other computers before, in the past, just not this newest version), and gets to the point where it says "Saving Bank 21".
- A window pops up complaining of an "Application error! Step: SQ", and, when cleared, another error comes up: "Application error! Step: Reset ID". The program stops running at this point (or, at least, returns to its idle state; one can try clicking on 'Track' but it will go through the same motions).
On rare occasion it will load up fine - on the inital start. When it comes time to save (at least, that's when I think this happens), the above crops up again.
Any thoughts?
application error: step: sq and application error: step: reset ID (on saving bank 21)
Couldn't find this discussed in the forums (searching is hard when one of the words is too short for the search engine and the other is fairly ubiquitous around here), so I'm going to post here.
I am trying to run ID Tracker on a laptop, an HP model 7010ca, running XP SP2 on 2gb RAM and a 60GB HD. It has no com port, but a Belkin USB2.0-to-serial adapter has done the task masterfully for years, handling the programming and monitoring of many of my radios over the RS232 connection.
The radio in question is a Uniden 796D. The baud rates are set the same in the program, the scanner, and Windows; the right COM port (2) for the adapter emulator is set; but every time I try to run ID Tracker it barfs on me. Here's what I get:
- The screen does the typical things ID Tracker does (I've had it run successfully on other computers before, in the past, just not this newest version), and gets to the point where it says "Saving Bank 21".
- A window pops up complaining of an "Application error! Step: SQ", and, when cleared, another error comes up: "Application error! Step: Reset ID". The program stops running at this point (or, at least, returns to its idle state; one can try clicking on 'Track' but it will go through the same motions).
On rare occasion it will load up fine - on the inital start. When it comes time to save (at least, that's when I think this happens), the above crops up again.
Any thoughts?
application error: step: sq and application error: step: reset ID (on saving bank 21)