Tim-B
Member
So, I programmed the Lower Colorado River Authority ECACS standard system in two scanners but neither receives anything. I am currently working in Columbus, TX and I put in the Columbus, Flatonia, and Schulenberg sites using the 1,2,3,4,5 order of frequencies as listed in the RR database as the LCN order. When I start scanning the scanner quickly goes through all sites without finding a control channel. It does pause for less than1 second on the Columbus site and I see the S meter go from 0 to 5 bars and back to 0 bars quickly before it moves on to the other two sites where it finds no CC's and the whole process starts over. All I see on the display is the S meter quickly flash 5 bars on then off in about 1/4 of a second as it checks the Columbus site. I have the system type set as EDACS and the sites set as wide/standard. The scanner I used are a BCD396XT and a BCD 436HP. Any ideas what I did wrong?