Darkstar350
Member
does the LMR 400 have PL 259 connectors? or does it depend on the manufacturer?
I know most RG8 have PL259
I know most RG8 have PL259
does the LMR 400 have PL 259 connectors? or does it depend on the manufacturer?
I know most RG8 have PL259
does the LMR 400 have PL 259 connectors? or does it depend on the manufacturer?
I know most RG8 have PL259
does the LMR 400 have PL 259 connectors? or does it depend on the manufacturer?
I know most RG8 have PL259
I know LMR 400 is pretty much the best of the best when it comes to coax...
I would say that the whole feeder system with RG214 would cost less than a single LMR-400 connector.
For a short run of 50' or less LMR400 is in my opinion overkill. Why not try simple RG214, it is a double braid coax, very flexible and in plentiful supply from just about any cable vendor (Anixter usually carries some). The basic N-Type either crimp or solder works well and can be replaced easily if needed, these come in PL259 or N-Type also and are inexpensive. I would say that the whole feeder system with RG214 would cost less than a single LMR-400 connector.
Standard PL-259 connectors will screw right on to LMR400. Just fold the braid back and screw the connector on, then solder the center pin.