Okay, so this is ignorance on my part, and its happened with my BCT 15X as well so hopefully a slap on the wrist and a stern "nice going dumb***", is all this'll take to fix this issue. So here is the annoying story...
I have a system programmed with multiple groups. While in a group, I turned off various groups in that system (system #99, groups 1-5). While in system #99, I turned off all the groups(1-5), and I'm greeted with "Nothing to Scan". Now whenever I try to select the system, it gives my the curt "I cant access/comply with your command, please try again" annoying beeps. I cant access the system, neither can I turn on the groups in that system.
Stupid mistake I know, but its really bugging me that I cant fix it. Last time this happened, I factory reset the BCT15X (I had to update the systems anyways so it wasn't a real loss).
I have a system programmed with multiple groups. While in a group, I turned off various groups in that system (system #99, groups 1-5). While in system #99, I turned off all the groups(1-5), and I'm greeted with "Nothing to Scan". Now whenever I try to select the system, it gives my the curt "I cant access/comply with your command, please try again" annoying beeps. I cant access the system, neither can I turn on the groups in that system.
Stupid mistake I know, but its really bugging me that I cant fix it. Last time this happened, I factory reset the BCT15X (I had to update the systems anyways so it wasn't a real loss).