Logging Multiple Sites

Status
Not open for further replies.

nickburns

Member
Joined
Dec 28, 2005
Messages
24
This may very well have been covered before but I cannot find a good answer. Is it possible with Unitrunker to monitor more than one site in a 9600 Smartzone Omnilink system without using more than one receiver? Thanks.


J
 

Deeke

Member
Joined
Mar 11, 2007
Messages
135
If you scan two different systems at the same time, you will get alot of corrupted data and false readings for sites that do not exist.

It's best to monitor oneat a time. If you change sites/systems, shut down and restart Unitrunker or disconnect and reconnect the sound input.
 
Last edited:

SCPD

QRT
Joined
Feb 24, 2001
Messages
0
Location
Virginia
nickburns said:
This may very well have been covered before but I cannot find a good answer. Is it possible with Unitrunker to monitor more than one site in a 9600 Smartzone Omnilink system without using more than one receiver?
The control channel provides very limited information about neighboring sites because there is no reason to provide more. The only way to tell what is happening at another site is to monitor the other site. As Deeke points out - you don't want the radio bouncing back-and-forth between sites - it will confuse the program and make a mess of your channel data.
 
Status
Not open for further replies.
Top